ClearTemp LC Veneer Cement: Temporary Try-In Guide
By Ultradent Products, Inc. | Published: 2026-11-01
Category: How-to Guides
Learn a step-by-step process for trying in temporary veneers with ClearTemp LC cement, including shade checks, light-cure try-in paste, and clean removal.
Quick answer
Use ClearTemp LC cement as a light-cured provisional veneer cement when you need a temporary try-in that lets you check fit and shade before final cementation. Load a small amount, seat the veneer, light-cure tack, evaluate, then remove cleanly.
Why use a light-cure try-in paste for temporary veneers
A light-cure try-in paste gives you working time to seat and adjust a temporary veneer without premature set. Because it stays where you place it until you light-cure, you can check margins, contacts, and shade under realistic conditions. ClearTemp LC is designed specifically for temporary veneers, so it balances retention with clean removal when the patient returns for the final restoration.
When ClearTemp LC is the right choice—and when it is not
ClearTemp LC works well for short-term provisional veneers where you want a light-cured cement that allows try-in evaluation. It is not intended as a permanent cement, and it should not be used where the temporary must withstand high functional loads for an extended period. If you need a dual-cure or self-cure provisional for areas with limited light access, consider a different product. Also note that the catalog does not list specific try-in paste shades or removal instructions, so verify those details with the manufacturer before use.
Step-by-step temporary veneer try-in with ClearTemp LC
- Isolate and clean the veneer: Clean the internal surface of the temporary veneer with alcohol and dry it thoroughly. Isolate the tooth with a dry field to prevent contamination. Checkpoint: any moisture or debris on the veneer will interfere with cement adaptation.
- Load a small amount of cement: Dispense a thin, even layer of ClearTemp LC into the veneer. Avoid overfilling, which can cause excess cement and difficult cleanup. Checkpoint: less is more—excess cement can seep into margins and complicate removal.
- Seat the veneer and check fit: Gently seat the veneer on the tooth and apply light pressure. Verify margins and contacts before light-curing. Adjust if needed. Checkpoint: do not light-cure until you are satisfied with the fit and shade.
- Tack-cure and evaluate shade: Light-cure for a few seconds to tack the cement, then evaluate the shade under appropriate lighting. If the shade is off, you can remove the veneer and clean it before proceeding. Checkpoint: use a try-in paste if you need to preview shade without committing to cement.
- Complete cure and clean margins: Once satisfied, light-cure according to the manufacturer’s instructions. Remove excess cement carefully with a scaler or floss before it fully sets. Checkpoint: incomplete cure can leave a tacky surface that attracts debris.
- Remove the temporary veneer: When the final restoration is ready, remove the temporary veneer by gently prying from the margin. Clean the tooth and veneer of residual cement. Checkpoint: use a proper removal instrument to avoid damaging the temporary or the tooth.
Product facts
- ClearTemp™ LC-Temporary Veneer Cement: ClearTemp LC cement is designed specifically for temporary veneers and is an award-winning Ultradent product. Its veneer-specific formulation helps you achieve a secure temporary try-in without the bulk or retention challenges of general provisional cements.
ClearTemp™ LC-Temporary Veneer Cement
